Multico HM, HML, HMT morticer parts

Parts for the Multico HM, HML and HMT: the 8, 10 and 12 mm chisel set (HM, HMT), the ¼″, ⅜″ and ½″ chisel and collet set (HM, HMT, HML), a 12 mm chisel (HM, HMT), the chisel clamps (HMT, HML), the MCL cone sharpener and the two chisel setting jigs.

The chisel sets, the 12 mm chisel and the chisel clamps are shared with the Model K. Part not listed? Send us the Multico part number or a photo and we'll check.

Other Multico models

What we stock for the HM, HML and HMT
Chisel sets
MULKSETM (8, 10, 12 mm; HM, HMT), MULKSETIMPERIAL1 (¼″, ⅜″, ½″; HM, HMT, HML)
Chisel
MB12, 12 mm; HM, HMT
Chisel clamps
H-61.790k; HMT, HML
Skip to results list
8 items

Frequently asked questions

Which chisel sets fit the HM, HML and HMT?

The metric set MULKSETM (8, 10 and 12 mm) is listed for the HM and HMT, and the imperial set MULKSETIMPERIAL1 (¼″, ⅜″ and ½″) for the HM, HMT and HML. The single MB12 chisel, 12 mm, fits the HM and HMT as well as the Models K and M.
What gap should I leave between the bit and the chisel?

About 0.8 mm (1/32″) for chisels up to ¾″, and about 1.6 mm (1/16″) for larger ones. Set it with a coin as a spacer.
How do I sharpen a mortise chisel?

Turn a sharpening cone inside the chisel, against the inside bevels, then rub the outside faces flat on a stone. Touch up the spurs of the auger bit with a file. Our MCL cone sharpener is listed for chisels from 3 to 25 mm (⅛″ to 1″).

Part not listed?

Send us the Multico part number, or a photo of the part and your machine's model, and we'll check.

Send a part enquiry